Cisco Wlc Group Configuration; Accessing Cisco Wlc Configuration; Navigating Cisco Wlc Configuration - Dell PowerConnect W-Airwave User Manual

Cisco WLC Group Configuration

The Groups > Cisco WLC Config page consolidates the settings for Cisco WLC devices from all group pages.
The Groups > SSIDs subtab applies to all device types except for Cisco WLC, which have WLANs configured
on the Cisco WLC Config page. It is not recommended to have Symbol 4131 and Proxim APs in the same group
as Cisco devices. Also, it is recommended that users set device preferences to Only devices in this group. This
topic describes how to access and navigate the Groups > Cisco WLC Config page.

Accessing Cisco WLC Configuration

Go to the Cisco WLC Config page in one of these two ways:
1. In Groups > List, select a group that has been defined to support Cisco devices and the Cisco WLC Config
option appears in the subtabs.
2. In Groups > List
Select Add from the Groups > List page to create a new group, enter a group name, and select Add.

Once AirWave prompts you with the Groups > Basic page, ensure that you enable device-specific settings

for Cisco WLC.
Once you select Save or Save and Apply, then the Groups > Cisco WLC Config subtab appears in the

navigation pane at the top in association with that group.

Navigating Cisco WLC Configuration

The navigation pane on the left side of the Groups > Cisco WLC Config page is expandable, and displays the
Cisco configurations supported and deployed.
You can pre-populate the group WLC settings from a controller in the same group by performing an import on
the controller's Audit page.
Figure 45 Groups > Cisco WLC Config Page Illustration, collapsed view
Figure 46 Groups > Cisco WLC Config Page Illustration, expanded view
Dell PowerConnect W-AirWave 7.4 | User Guide
create a new group to support Cisco devices with these steps:
,
Figure 45 and Figure 46 illustrate this navigation pane.
Configuring and Using Device Groups in AirWave | 91