Configuring Basic Group Settings - Dell PowerConnect W-Airwave User Manual

NOTE: When you first configure AWMS, there is only one default group labeled Access Points. If you have no other groups
configured, refer to

Configuring Basic Group Settings

The first default device group that AWMS sets up is the Access Points group, but you can use this procedure to
add and configure any device group. Perform these steps to configure basic group settings, then continue to
additional procedures to define additional settings as required.
1. Go to the Groups > List page. Existing device groups appear on this page.
2. To create a new group, select Add. Enter a group name and select Add. The Groups > Basic page appears.
To edit an existing device group, select the manage (wrench) icon next to the group. The Groups > Basic
page appears. If you mouse over an existing group's wrench, a popup menu allows you to select Basic,
Templates, Security, SSIDs, AAA Servers, Radio, Dell PowerConnect W Config or Cisco WLC Config to
edit those pages as desired, as illustrated in
Figure 36 Pop-up When Hovering over Wrench Icon in Groups > List
Figure 37
72 | Configuring and Using Device Groups in AWMS
"Configuring Basic Group Settings" on
illustrates an example Groups > Basic page.
page 72.
Figure 36.
Dell PowerConnect W AirWave 7.2 | User Guide