Airflow Guide; Removing The Airflow Guide - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Airflow guide

This section describes how to remove and install the chassis airflow guide.

Removing the airflow guide

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the airflow guide by lifting firmly on the handle at the green touch point , and then rotating
the airflow guide upward
Figure 5-4
4. Disengage the airflow guide tabs from the rear chassis slots
the chassis
Figure 5-5
ENWW
as shown in the following figure.
2
Releasing the airflow guide
as shown in the following figure.
2
Removing the airflow guide
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
74).
76).
, and then lift the airflow guide from
77