HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 130

7. Connect the data cable to the hard drive
following illustration.
If the hard disk drive is SAS, attach a SATA-SAS adapter to the drive before connecting the data
cable.
TIP:
Figure 5-56
8. Connect the chassis power cable to the slot load optical drive power cable.
Figure 5-57
118 Chapter 5 Replacing components
Route the data cable along the system board.
Connecting the hard drive data cable to the drive
Connecting chassis and slot load optical drive power cables
and to the system board connector as shown in the
2
ENWW