Pcie Card; Removing A Pcie Card - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

PCIe card

This section describes how to remove and install a PCIe card.

Removing a PCIe card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support (see
4. Remove all cables connected to the PCIe card.
5. Raise the rear retention clamp by lifting the metal bar or the green lever
figure. If necessary, disconnect the auxiliary power cable (not illustrated).
Figure 5-94
6. Release the PCIe card latch
TIP:
7. If you are removing a PCIe card without a release lever, lift the card out of the slot.
8. If you are not installing a PCIe card, install a PCI slot cover and close the expansion card retention
clamp. The retention clamp is secured by the expansion card support.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
148 Chapter 5 Replacing components
Removing a PCIe card
2
Store the card in an antistatic bag.
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
, and then carefully lift the card from the chassis
74).
76).
78).
as shown in the following
.
ENWW