HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 156

6. Align the DIMM connector key with the DIMM socket key, and then seat the DIMM firmly in the
socket
CAUTION:
damage, align these guides properly when installing DIMMs.
Figure 5-92
7. Secure the socket levers
8. Reinstall all removed components and reconnect any cables that have been disconnected.
NOTE:
BIOS errors and warnings on page 140
144 Chapter 5 Replacing components
as shown in the following figure.
DIMMs and their sockets are keyed for proper installation. To prevent socket or DIMM
Seating the DIMM
.
2
If you receive a DIMM-related error message after you re-start the workstation, refer to
for error message information.
ENWW