HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 165

6. Align the PCI card keyway with the slot key, and then firmly seat the card in the slot as shown in
the following figure
Figure 5-99
7. Close the expansion card retention clamp by rotating it downward
secured by the expansion card support.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
8. Install the expansion card support (see
9. Reinstall all removed components and reconnect any cables that have been disconnected.
ENWW
.
Installing a PCI card
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
Installing the expansion card support on page
Removing and installing components 153
. The retention clamp is
2
80).