Power Switch Cable Assembly; Removing The Power Switch Cable Assembly - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Power switch cable assembly

This section describes how to remove and install the power switch cable assembly.

Removing the power switch cable assembly

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support (see
4. Remove the expansion card guide/front fan holder (see
fan holder on page
5. Remove the right side panel (see
6. Remove the front bezel (see
7. Disconnect the speaker (see
8. Cut the cable ties
following figure.
Figure 5-20
9. Remove the cable assembly by pulling cables through the lower right chassis wall opening and the
front chassis wall opening.
ENWW
127).
Removing the right side panel on page
Removing the front bezel on page
Removing the speaker on page
, and then move the power switch cable assembly screw
Loosening the power switch cable assembly
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
Removing the expansion card guide/front
Removing and installing components
74).
76).
81).
86).
82).
as shown in the
2
78).
91