Download  Print this page

Cpu Heatsink; Removing The Cpu Heatsink - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Hp z800 workstation maintenance and service guide.
Hide thumbs

Advertisement

CPU heatsink

This section describes how to remove and install a CPU heatsink.

Removing the CPU heatsink

1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Remove the memory fans (see
5.
Remove the airflow guide (see
6.
Slowly and evenly loosen one pair of diagonally opposite screws
shanks disengage from the system board, and then loosen the remaining pair
following figure.
CAUTION:
screws a little at a time, ensuring that the CPU remains level.
Figure 5-122
172 Chapter 5 Replacing components
Predisassembly procedures on page
Removing the memory fans on page
Removing the airflow guide on page
Do not fully loosen one screw, and then move on to the next. Instead, loosen all
Loosening heatsink screws in sequence
Predisassembly procedures on page
Removing the side access panel on page
74).
74).
76).
137).
77).
from the CPU until the screw
as shown in the
2
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z800 - Workstation - 6 GB RAM

This manual is also suitable for:

Z800

Comments to this Manuals

Symbols: 0
Latest comments: