HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 113

7. If a hard disk drive is installed, disconnect its power and data cables.
8. Lift and hold the drive release latch at the green touch point , and then slide the slot load assembly
out of the chassis
TIP: Push on the slot load assembly from the inside of the chassis.
Figure 5-31
9. Disconnect the power/data cable from the slot load optical disk drive.
Figure 5-32
ENWW
as shown in the following figure.
2
Removing the slot load assembly
Disconnecting the power/data cable from the drive
Removing and installing components 101