Pci Card; Removing A Pci Card - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

PCI card

This section describes replacing a PCI card.

Removing a PCI card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support (see
4. Remove all cables connected to the PCI card.
5. Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following
figure
Figure 5-97
6. Lift the PCI card out of the chassis
TIP: Store the card in an antistatic bag.
7. Install a PCI slot cover and close the expansion card retention clamp. The retention clamp is
secured by the expansion card support.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
ENWW
.
Removing a PCI card
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
.
2
Removing and installing components 151
74).
76).
78).