Installing the slot load optical disk drive
1.
With power off and the side access panel open, remove the expansion card support and any card
cables that might interfere with slot load assembly installation.
2.
Remove the airflow guide (see
3.
Insert the optical disk drive in the carrier at an angle
Rotate the drive vertical, and then push it down until it snaps into place
Figure 5-34
4.
Connect the power/data cable to the optical disk drive.
TIP:
Place excess cabling in the slot load optical bay.
Figure 5-35
ENWW
Removing the airflow guide on page
Install the optical disk drive in the carrier
Connecting the power/data cable to the drive
77).
.
.
2
Removing and installing components 103