Side Access Panel; Removing The Side Access Panel; Installing The Side Access Panel - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Side access panel

Before accessing the internal components of the workstation, you must remove the side access panel.
This section describes how to remove and install the side access panel.

Removing the side access panel

WARNING!
powered off and that the power cord is disconnected from the electrical outlet.
1. Disconnect power from the workstation (see
2. Remove locks that are present, such as cable lock or side access panel key lock.
3. Pull up on the handle
figure.
Figure 5-3

Installing the side access panel

1. Align the bottom groove of the side access panel with the bottom edge of the chassis.
2. Rotate the side access panel toward the chassis and press firmly until the latch engages.
76 Chapter 5 Replacing components
Before removing the workstation side access panel, be sure that the workstation is
and rotate the side access panel off the chassis
Removing the side access panel
Predisassembly procedures on page 74).
as shown in the following
2
ENWW