Replicating The Setup; Copying A Setup Configuration To A Single Workstation - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Replicating the setup

This section provides information about replicating the workstation setup.

Copying a setup configuration to a single workstation

CAUTION:
target workstations are not the same model.
To copy a setup configuration:
1. Select a setup configuration to copy, and then restart the workstation.
2. Power off the workstation you are configuring and insert the configuration diskette into the diskette
drive or USB media device.
3. As soon as the workstation powers on, press and hold
(F10) Utility. If necessary, press
NOTE:
press and hold
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
4. Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen
to create the configuration diskette or USB media device.
5. Power on the workstation you are configuring.
6. Press and hold the
Enter
7. Select File>Replicated Setup>Restore from Removable Media, and then follow the instructions
on the screen.
8. Restart the workstation when the configuration is complete.
44 Chapter 4 System management
A setup configuration is model-specific. File system corruption can result if source and
If you do not press F10
F10 again to access the utility.
F10 key until you enter the Computer Setup (F10) Utility. If necessary, press
to bypass the title screen.
F10
Enter to bypass the title screen.
at the appropriate time, you must restart the workstation, and then
until you enter the Computer Setup
ENWW