HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 162

7. Angle the card into the PCI card guide. Align the PCIe card keyway with the slot key, and then
firmly seat the card in the slot as shown in the following figure
If required by the card, connect the auxiliary power cable to the card (not illustrated), or other cables
or accessories described in the card instructions. (See
fan holder on page 127
Figure 5-96
8. Close the expansion card retention clamp by rotating it downward
secured by the expansion card support.
NOTE:
when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly
seated and all the brackets are mated to the chassis, then re-close the clamp.
9. Install the expansion card support (see
10. Reinstall all removed components and reconnect any cables that have been disconnected.
150 Chapter 5 Replacing components
to find the storage location of the auxiliary power cables.)
Installing a PCIe card
It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle
Removing the expansion card guide/front
Installing the expansion card support on page
.
. The retention clamp is
2
80).
ENWW