Front Bezel; Removing The Front Bezel; Installing The Front Bezel - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Front bezel

This section describes how to remove and install the front bezel.

Removing the front bezel

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the right side panel (see
4. Remove the four T-15 Torx screws
the following figure
Figure 5-15

Installing the front bezel

To install the front bezel, position the bezel on the chassis and install the screws.
86 Chapter 5 Replacing components
Removing the right side panel on page
.
2
Removing the front bezel
Predisassembly procedures on page
Removing the side access panel on page
, and then remove the bezel from the chassis as shown in
74).
76).
81).
ENWW