Slot Load Optical Disk Drive (Optional); Removing The Slot Load Optical Disk Drive - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Slot load optical disk drive (optional)

A slot load optical disk drive can be added to the workstation in place of the standard optical disk drive
assemblies. The slot load optical bay fits into the chassis and replaces all the standard optical bays.
This section describes how to remove and install a slot load optical disk drive.

Removing the slot load optical disk drive

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the expansion card support and any card cables that might interfere with slot load
assembly removal.
4. Remove the airflow guide (see
5. Disconnect the slot load optical disk drive data cable from the system board connector as shown
in the following figure.
Figure 5-29
6. Disconnect the chassis power cable from the slot load optical drive power connector as shown in
the following figure.
Figure 5-30
100 Chapter 5 Replacing components
Removing the airflow guide on page
Disconnecting the data cable from the system board
Disconnecting chassis power cable from optical disk drive power cable
Predisassembly procedures on page
Removing the side access panel on page
74).
76).
77).
ENWW