Installing Sata Hard Drives In The Optical Drive Bays (Optional) - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

Installing SATA hard drives in the optical drive bays (optional)

1. If necessary, remove the EMI shield.
2. Disconnect power from the system
access panel
(Removing the front bezel on page
3. Place the SATA hard drive in the drive bracket (1), and then install four silver, ANSI 6–32 screws
through the bracket and into the hard drive as shown in the following figure (2).
Figure 5-56
4. Install additional black, metric M3 screws into the bracket (1). Align the screws with the grooves in
the optical drive bay, and then slide the drive into the workstation chassis (2).
Figure 5-57
100 Chapter 5 Removal and replacement procedures
(Predisassembly procedures on page
(Removing the side access panel on page
65).
Installing the hard drive in bracket
Installing the hard drive in the optical drive bay
57), remove the side
61), and then remove the front bezel
ENWW