Slot Load Optical Disk Drive (Optional); Removing The Slot Load Optical Disk Drive - HP Z600 Maintenance And Service Manual

Slot load optical disk drive (optional)

A slot load optical disk drive can be added to the workstation in place of the standard optical disk drive
assemblies. The slot load optical bay fits into the chassis and replaces the standard optical bays.
This section describes how to remove and install a slot load optical disk drive.

Removing the slot load optical disk drive

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
NOTE:
the card support is removed, allowing access to the expansion cards.
3. Remove any expansion card cables that might interfere with slot load assembly removal.
4. Disconnect the chassis power cable from the slot load optical disk drive power cable as shown in
the following figure.
Figure 5-27
ENWW
An expansion card support is built into the side access panel. When the panel is removed,
Disconnecting chassis power cable from optical disk drive power cable
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
73).
75).
97