Installing Hard Drives In The Optical Drive Bays (Optional) - HP Xw4400 - Workstation - 2 GB RAM Reference Manual

5. Connect the data cable from the hard drive (1) to the serial ATA port (2). SATA0 port is shown in
the following illustration.
● Connect SATA 0 to SATA0.
●
Connect SATA 1 to SATA1.
Figure 4-50
To install three to four SATA hard drives:
1. Follow the instructions for installing two SATA hard drives above.
2. Follow the instructions for installing the hard drive into the optical drive slot.
NOTE:
drive bay. If installing four SATA hard drives, you must install hard drives in at least two optical
drive bays.
3. Connect the data and power cable to the drives.
●
Connect SATA 2 to SATA2.
●
Connect SATA 3 to SATA3.

Installing hard drives in the optical drive bays (optional)

1. Disconnect power from the system
access panel
ENWW
Connecting the SATA cable to the hard drive
If installing three SATA hard drives, you must install hard drives in at least one optical
(Side access panel on page
(Predisassembly procedures on page
62), and the front bezel
Steps for removal and replacement of components
57), remove the side
(Front Bezel on page 63).
93