Front I/O And Power Switch Assembly - HP EliteDesk 800 G3 TWR Maintenance And Service Manual

Front I/O and power switch assembly

The front I/O and power switch assembly is attached to the front of the chassis with one screw. Pull the
assembly away from the front of the chassis to remove.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the drive cage
5. From the inside of the computer, disconnect the cables from the following system board connectors:
● FRONT USB (blue connector)
● PB/LED (black connector)
● FRONT USB 3.1 (blue connector)
● FRONT USB 3.1 TYPE C (black connector)
● FRONT USB (yellow connector)
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 21).
(Drive cage on page 28).
19).
20).
Front I/O and power switch assembly 55