Power Switch Cable Assembly; Removing The Power Switch Cable Assembly - HP Z800 Workstation Maintenance And Service Manual

Power switch cable assembly

This section describes how to remove and install the power switch cable assembly.

Removing the power switch cable assembly

1.
2.
3.
4.
5.
6.
7.
8.
9.
ENWW
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the expansion card support (see
Remove the expansion card guide/front fan holder (see
fan holder on page 129).
Remove the right side panel (see
Remove the front bezel (see
Disconnect the speaker (see
Cut the cable ties , and then move the power switch cable assembly screw
following figure.
Figure 5-20 Loosening the power switch cable assembly
Remove the cable assembly by pulling cables through the lower right chassis wall opening and the
front chassis wall opening.
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
Removing the right side panel on page
Removing the front bezel on page
Removing the speaker on page
Removing and installing components
78).
Removing the expansion card guide/front
83).
88).
84).
as shown in the
2
76).
80).
93