Panasonic AJ-HPD2500 Operating Instructions Manual page 35

through connector, the REF VIDEO IN connector is
automatically terminated at 75 ohm. Connecting a cable to
this connector releases 75 ohm termination. When a cable
is connected to the REF VIDEO loop-through connector, be
sure to connect the other end of the cable to a connector.
• At 720P recordings that input or do not input an HD
reference signal, the phase of the input signal may be
displaced in the recording of the signal.
• When setup menu No. 25 (SYSTEM FREQ) is set to 59-23,
60-24 or 60-25, only playback is synchronized to the HD
reference signal.
• Use double shielded cable for making connection to REF
VIDEO IN connector.
6.
ANALOG VIDEO IN/MON connector
IN connector: Inputs analog composite video
signals.
When no cable is connected to the
loop through connector, the IN
connector is automatically
terminated at 75 ohm. Connecting
a cable to this connector releases
75 ohm termination.
MON connector: Outputs analog composite monitor
video signals.
◆ NOTE:
• Use double shielded cable for making connections to
ANALOG VIDEO IN/MON connectors.
7.
AC IN socket
Connect the supplied power cord to a power outlet.
8.
LAN connector
Use this connector to connect to a 1000BASE-T/
100 BASE-TX/10BASE-T network.
➝Refer to "Connecting This Unit to a Network" (page 130).
◆ NOTE:
• Use a shielded cable for a connection to the LAN connector.
• A green LED lights to indicate that the LAN link is
established in100BASE-T mode. An orange LED blinks
during data transfer.
9.
PARALLEL IN/OUT connector
This is a 25-pin parallel remote connector.
Pin No. Signal
1 PLAY COMMAND
2 STOP COMMAND
3 FF COMMAND
4 REW COMMAND
5 REC COMMAND
6 —
7 SHTL 0.0 COMMAND
9 —
10 CLIP SELECT OFF COMMAND
11 1 CLIP PLAY COMMAND
12 +10 V or more, +300 mA max.
13 PLAY STATUS
14 STOP STATUS
15 FF STATUS
16 REW STATUS
17 REC STATUS
18 EJECT STATUS
19 STAND BY ON STATUS
20 —
21 —
22 OPERATION ENABLE STATUS
23 CLIP SELECT STATUS
24 —
25 GND
◆ NOTE:
• Use COMMAND at TTL level, low active (negative logic)
and of electrical signals with an edge of 100 msec or more.
• STATUS outputs open collector and sync current up to
6 mA.
• OPERATION ENABLE STATUS becomes active when
playback from PARALLEL REMOTE is available with the
setup menu 213 EXTENDED CMD set to ON.
• OPERATION ENABLE STATUS becomes active at the
REMOTE status with the setup menu 213 EXTENDED CMD
set to OFF.
• Use shielded cable for making connections to PARALEL
IN/OUT connectors.
10.
ENCODER REMOTE connector
Connect an external encoder remote controller to
adjust video output signal settings.
Pin No. Signal
1 FRAME GROUND
Introduction: Control Reference Guide
35