Gui Operations - Panasonic AJ-HPD2500 Operating Instructions Manual

GUI Operations

LCD Monitor
1.
THUMBNAIL button
Press this button and the button lights, and the
thumbnail screen appears on the LCD monitor. Press
again to return to the recording/playback mode and
the button goes out.
Setting setup menu No. 051 (GUI OUTPUT) allows you
to transfer the thumbnail screen and the playlist screen
to the video output.
2.
PLAY LIST button
Press to start or end playlist mode.
➝Refer to "Playlist Function" (page 78).
3.
Cursor buttons (b / a / 4 / 5)
The four outer buttons are cursor buttons. Use them to
move the cursor in thumbnails, menus, events, etc. The
SET button at the center is used to select menu items
and clips.
In the thumbnail or playlist screen, hold down the
SHIFT button and press a cursor button to move the
cursor to the beginning or the end. Or hold down the
SHIFT button and press the SET button to select
multiple clips or events.
Holding down the SET button in the playlist screen,
selects all track events with the same IN and OUT
points as the event at the cursor.
26
Introduction: Control Reference Guide
Display Panel
6 7 8 9 11 13 15 17
10
12 14
4.
MENU/DIAG/OPERATION button
1 2 3
16 18
MENU button
Press this button to open the setup menu, thumbnail or
playlist menus. Press again to return to the previous
screen.
➝Refer to "Moving Between Screens and Menu
Operations" (page 37).
Refer to "Setup" (page 164).
DIAG (SHIFT + MENU) button
When not in the thumbnail or playlist screen, press this
button to show information about this unit. Press again
to return to the previous screen. However, in the
thumbnail or playlist screen, it has the same effect as
pressing the OPERATION (SHIFT+MENU) button.
Information about this unit includes [VIDEO SYSTEM],
[WARNING], [HOURS METER] and [UMID]. Use the
SET button or the right and left cursor buttons (b / a)
to switch among them.
[VIDEO SYSTEM] Shows current system frequency,
screen: recording format, input and
output formats and other
information.
[WARNING] Shows warning information.
screen:
[HOURS METER] Shows the unit serial number, the
screen: number of hours it has been on,
and the number of times it has
been switched on and off.
4
5