Copying Clips To A Hard Disk - Panasonic AJ-HPD2500 Operating Instructions Manual

5
Use the cursor buttons to choose [HDD (USB or
eSATA)] – [EXPORT] and press the SET button.
6
Select the number of the source P2 card slot and
press the SET button.
Selecting ALL SLOT will result in a batch export of all
inserted cards.
7
Select [YES] and press the SET button.
The data will now be exported. A progress bar appears
during exporting.
◆ NOTE:
• In the factory default settings, verify is enabled for export. The
export operation will end earlier when verify is disabled though
exported data is not checked.
To turn off this setting, choose [HDD (USB or eSATA)] – [SETUP]
– [VERIFY] – [OFF].
• To interrupt exporting, press the SET button, select [YES] in the
CANCEL confirmation that appears and press the SET button
again.
• Data copied from a P2 card will not be affected if processing
should be interrupted during verification.
• When a hard disk is connected to a PC and the network
assignment conflicts with drive assignment and a partition
cannot be seen, use our drive mount converter available free of
charge from the URL listed below. This allows you to mount the
specified folder when a hard disk is connected to a Windows
PC.
For English: http://pro-av.panasonic.net/
When the export operation ends, "COPY COMPLETED!"
appears.

Copying Clips to a Hard Disk

Use the following steps to copy selected clips rather than
entire cards to a hard disk.
2
2,4,5,6
1
Connect a hard disk.
2
Press the THUMBNAIL button to open the thumbnail
screen, select the clip to copy using the cursor
buttons, and press the SET button to confirm.
You can also select multiple clips.
3
Press the MENU button.
4
Use the cursor buttons to select [OPERATION] –
[COPY] – [HDD (USB or eSATA)] and press the SET
button.
Connections: Using This Unit With a Hard Disk
3
121