Panasonic AJ-HPD2500 Operating Instructions Manual page 27

[UMID] screen: Shows UMID information for the
current video.
OPERATION (SHIFT + MENU) button
In the thumbnail and playlist screen (when no menu is
displayed), press the SHIFT button and this button
simultaneously to show and select the [OPERATION]
menu.
5.
EXIT/CANCEL/PF button
When the PLAYLIST/
THUMBNAIL buttons
are lit:
When the PLAYLIST/
THUMBNAIL buttons
are off:
6.
EDIT MODE button
Use to select edit mode in the playlist mode.
➝Refer to "Buttons Used in Playlist Operations" (page
86).
7.
VIDEO button
Use to select material for editing (video) in the playlist
mode.
➝Refer to "Buttons Used in Playlist Operations" (page
86).
8.
A1/A3 button
Use to select target for editing in the playlist mode
(audio channels 1 and 3).
➝Refer to "Buttons Used in Playlist Operations" (page
86).
Press this button to return
from clip property, card
status or HDD thumbnail to
the previous screen.
Selecting [EXIT] in a menu
has the same effect as
pressing the SET button.
Press the SHIFT button and
this button simultaneously to
cancel a selection.
Press this button to use the 12
(IN), 14 (ENTRY) and 16
(OUT) buttons as PF1 to PF3,
respectively.
Press this button again
before pressing another
button and this mode will
close after a short interval.
➝Refer to "Making changes
using the PF buttons"
(page 165).
9.
A2/A4 button
Use to select target for editing in the playlist mode
(audio channels 2 and 4).
➝Refer to "Buttons Used in Playlist Operations" (page
86).
10.
LAST X/DELETE button
LAST X button
In the playlist mode, use this button to return a previous
editing operation.
➝Refer to "Buttons Used in Playlist Operations" (page
86).
DELETE (SHIFT+LAST X) button
In the thumbnail or playlist screen, press this button to
delete the selected clip or event.
11.
GO TO/A. DUB MODE button
GO TO button
Hold down this button and press the IN/OUT button to
cue up to an IN or OUT point.
◆ NOTE:
• Cue up may fail when the time code is not continuous. Be
sure to use a continuous time code.
A. DUB MODE (SHIFT + GOTO) button
Press this button to engage the A. DUB mode and
record voice-overs.
➝Refer to "Recording Voice-Overs" (page 106).
12.
IN/SLOT CLIP/PF1 button
IN button
Use this button to perform the following functions
during clip playback or when the unit is controlled
externally.
• IN+ENTRY
Press the ENTRY button and this button to set an IN
point.
• IN
Press this button to confirm a set IN point. "--:--:--:--"
is displayed when no point has been set.
• IN+RESET
Press the RESET button and this button
simultaneously to delete the current IN point.
• IN+GOTO
Press the GOTO button and this button
simultaneously to cue up to the set IN point.
SLOT CLIP (SHIFT + IN) button
In the thumbnail screen, each simultaneous press of
the SHIFT button and this button switches the clip
display between a specific slot or selected clip.
Introduction: Control Reference Guide
27