Panasonic AJ-HPD2500 Operating Instructions Manual page 131

Setting:
Item Description
MAC ADDRESS MAC ADDRESS (unique ID)
DHCP DHCP setting
IP ADDRESS IP address
SUBNET MASK Subnet mask
DEFAULT GATEWAY Default gateway
PRIMARY DNS Set primary DNS server
SECONDARY DNS Set secondary DNS server
NETWORK Network service start setting
◆ NOTE:
• When NETWORK is set to ENABLE, starting up may take longer time since the unit will connect to the network when it is turned on.
• The network cannot be accessed when NETWORK is set to DISABLE. A switch between ENABLE and DISABLE does not take effect until the
unit is restarted.
• A change in setting may lengthen the time required for the setup screen to close since the network service will have to be restarted using a
different setting.
• When DHCP is set to ENABLE, settings other than MAC ADDRESS and NETWORK are disabled.
• IP address, subnet mask and default gateway must be correctly combined.
If the "CANNOT ACCESS GATEWAY!" warning appears as the setup screen closes, consult the network administrator.
• Set 0.0.0.0 when default gateways or DNS will not be used.
• DHCP and DNS may not operate properly in some network environments.
Client setting
Follow the steps below to make the required settings such as
an address of connection server to use the FTP client to
transfer clips or the HTTP browser.
1
Open the thumbnail screen.
2
Press the MENU button.
3
Use the cursor buttons to choose [NETWORK] –
[SETUP] – [CLIENT] and press the SET button.
FTP CLIENT:
Item Description
URL Name or address of
connection server
USER ID ID of the user making the
connection
USER PASSWORD Password for user making the
connection.
SSH Set to use SSH for file
transfers.
• The set password cannot be displayed on this unit.
Set value
Cannot be changed.
ENABLE: Uses DHCP (automatic assignment)
DISABLE: Does not use DHCP (automatic
assignment)
Enter using the ten keypad
Enter using the ten keypad
Enter using the ten keypad
Enter using the ten keypad
Enter using the ten keypad
ENABLE: Starts network service when the unit is
turned on.
DISABLE: Does not start network service.
4
The client setup screen appears.
Current settings appear.
Use the cursor buttons to select an item and press the SET
button to set it.
Setup procedure
Enter using the full keyboard. (up to 500 characters).
Enter using the full keyboard. (up to 31 characters)
Enter using the full keyboard. (up to 31 characters)
ENABLE: Enables SSH.
DISABLE: Disables SSH.
Connections: Connecting This Unit to a Network
Factory defaults
Set value (cannot be
changed)
DISABLE
192.168.0.2
255.255.255.128
192.168.0.1
0.0.0.0
0.0.0.0
DISABLE
Factory defaults
No setting
No setting
No setting
DISABLE
131