Interface - Panasonic AJ-HPD2500 Operating Instructions Manual

Item
FR SUPER
No. DISP.
0000
0001
160 REPEAT PLAY
0000
0001
165 CLIPSEL MODE
0000
0001
170 AVCHD REC

INTERFACE

This menu specifies the ID data that will be returned to the controller.
Item
FR SUPER
No. DISP.
0000
0001
0002
202 ID SEL
0000
0001
213 EXTEND CMD
Setting
FR SUPER
No. DISP.
OFF Determines whether or not to engage repeat play during playback.
0: Does not engage repeat play. Stops playback at the end of the last clip.
ON
1: Engages repeat play. Continues playback from the beginning when reaching the end
of the last clip.
NOTE:
• Repeat play is not available when the PLAY LIST button is on and during TEXT MEMO
playback.
• If the P2 card is removed during repeat play, playback is suspended when playback
reaches the clip that is no longer exists.
• Even if you insert a P2 card during repeat play, additional clips are not played back
until you once stop repeat play and resume it.
TOP
59.94Hz
THUMB
Selects position of clip displayed by clip select.
0: Uses the first frame of the clip to select clips.
1: Uses clip thumbnail position to select clips.
OFF
59.94Hz
ON
Selects whether to make AVCHD recording to an SD card either in AVCHD mode or
simultaneous with recording to a P2 card.
0: No AVCHD recording
1: Makes an AVCHD recording to an SD card either in AVCHD mode or simultaneous with
recording to a P2 card.
NOTE:
• Displayed only when an AJ-YCX250G AVCHD codec board (optional) is installed.
• AVCHD recording is not available when 480i or 576i is set in setup menu No. 020 (SYS
FORMAT). Select up-conversion recording to record 480i and 576i input as AVCHD.
• Use the setup menu No.774 (AVCHD A CH) to select channels to record.
• The start and end of recording may not match the clip recorded on the P2 card.
• AVCHD recording is not available when setup menu No. 041 (LOOP REC) is set to
ON.
Setting
FR SUPER
No. DISP.
OTHER Specifies the ID data that will be returned to the controller.
DVCPRO 0: OTHER
1: DVCPRO
ORIG
2: ORIG
NOTE:
• Select [OTHER] for ID data for a VTR other than a DVCPRO.
• Select [ORIG] only when specific Panasonic controllers (such as AJ-A850, separately
sold accessory) are connected.
OFF Determines whether or not REMOTE connector commands should be extended to the clip
select function and the LAN and USB switching function.
ON
0: Not extended
1: Extended
Settings and brief function description
50Hz only
50Hz only
• XX indicates factory default settings.
Settings and brief function description
179
Setup: Item Settings