Panasonic AJ-HPD2500 Operating Instructions Manual page 208

The following warning messages appear when an incorrect operation is attempted in the thumbnail playlist screen.
Item Message
CANNOT ACCESS
GATEWAY!
CHECK LAN SETTING
CANNOT ACCESS!
CANNOT ADD! NO
INPUT
CANNOT CHANGE!
CANNOT CONNECT! Connection to the network cannot be established. Check LAN setup, make sure the LAN cable is
CANNOT DELETE!
CANNOT FIND
FTP-SERVER!
CANNOT FORMAT!
CANNOT
RE-CONNECT!
CANNOT REPAIR IN
SELECTION!
CANNOT REPAIR!
CANNOT SAVE!
FILE NAME IN USE
CARD FULL!
Thumbnail
INVALID VALUE!
IP ADDRESS IS
USED!
LACK OF REC
CAPACITY!
LOGIN FAILED!
MISSING CLIP!
NO CARD!
NO CONTENTS!
NO COPY TO SAME
CARD!
NO INPUT!
NO SD CARD!
NOT SELECTED!
PING FAILED!
CHECK LOG or
SET FTP-URL
SAME CLIP IS
SELECTED!
TOO MANY CLIPS!
UNKNOWN
CONTENTS
FORMAT!
208
For Long and Trouble-Free Operation: Error Messages
Description
Cannot access gateway server.
Data cannot be accessed because it is corrupted
or for other reasons.
User name or password in not entered correctly. Enter user name or password correctly.
A thumbnail containing a grayed out text memo that
cannot be generated is not available for editing.
Contents version mismatch prevents deletion.
FTP server cannot be found.
P2 card problem prevents formatting.
A clip that does not span multiple cannot be
reconnected.
Some of the selected clip could not be repaired.
Selected content cannot be repaired.
A network setup file with the same file name
exists on the SD memory card.
The P2 or SD memory card is full.
Entered data was invalid.
The set IP address is used on another device.
There is not enough recording capacity left on the
card.
Login to destination FTP server failed.
All cards that contain the clip must be inserted to
allow attachment of shot marks.
No P2 or SD memory card is inserted.
No P2 data in the connected network folder.
A clip cannot be copied to the card storing the
original clip.
No data is input.
No SD memory card is inserted.
An attempt was made to delete an unselected
clip.
PING failed.
The selected clips contain multiple copies of the
same clip (duplicated using COPY).
Too many clips are selected.
This warning appears when data not compatible
with the unit is detected.
Measure
Check if LAN setup is correct.
Restore media and clips to normal state before
access. When displayed during network operation,
check LAN setup, make sure the LAN cable is
correctly connected and check that your network
environment is functioning properly.
Edit settings or content to enable thumbnail display.
correctly connected and check that your network
environment is functioning properly.
Match devices and contents version.
Check if FTP client URL is correct.
Check P2 card.
Check selected content.
Check selected content.
Save to a different name.
Insert media with sufficient capacity.
Enter data in a valid range.
Consult the network administrator, and set another
IP address.
Insert a card with sufficient recording capacity.
Check if user ID and password for the FTP client are
correct.
Insert all cards that contain the clip.
Insert compatible media.
Connect to a folder that contains P2 data.
Copy the selected clip to a card that does not
contain the original clip.
Set after making input.
Insert an SD memory card.
Select the clip you want to delete.
Check if LAN setup, FTP client URL and LAN cable
connection are correct.
Multiple copies of the same clip (duplicated using
COPY) cannot be simultaneously copied. Deselect
all identical copies from the selected clips.
Reduce the number of selected clips.
• Match devices and contents version.
• If a bad clip exists (in the copy destination in case
of copy), repair or remove the bad clip.