Loading Set Metadata Values - Panasonic AJ-HPD2500 Operating Instructions Manual

Counter value
The counter value is indicated as a four-digit number. When
recording method "TYPE 2" is selected for the USER CLIP
NAME in the clip metadata that is loaded, the counter value is
incremented by 1 for each new recording and a new clip is
generated.
■ To reset the counter value
Use the following procedure to reset the counter value.
1.
Open the thumbnail screen.
2.
Press the MENU button.
3.
Use the cursor buttons to choose [META DATA] –
[PROPERTY] – [USER CLIP NAME] and press the
SET button.
4.
Use the cursor buttons to select [COUNT RESET]
and press the SET button.
The counter value is reset to 1.
5.
Press the EXIT button to end processing.
■ Incrementing the counter value of the USER
CLIP NAME for clips exceeding 4 GB
In the following case, one shot is recorded as multiple clips
and the counter value is automatically incremented and
recorded for each shot.
• When an 8 GB or larger P2 card is used in this unit and each
continuous recording exceeds a preset time.
➝For details, refer to "Dividing clips over 4 GB in length"
(page 42)
• When one recording spans multiple cards.
Example of a recording on one P2 card (DVCPRO HD):
REC start
(start of recording)
Recording duration = 6 minutes
Clip 1
Counter value = A
Approx. 5 min.
Example of recording a clip on two P2 cards:
REC start
(start of recording)
Clip 1
Counter value = A
1st card
A P2 device will indicate the thumbnail and the counter value
of clip 1 when thumbnails and property of the clip are
displayed.

Loading Set Metadata Values

Use the following procedure to load metadata from an SD
memory card.
1
Insert the SD memory card storing the metadata
upload file.
2
Open the thumbnail screen.
3
Press the MENU button.
Clip Management: Attaching Metadata to Clips
Stop
(recording stop)
Clip 2
Counter value = A + 1
Approx.
1 min.
Stop
(recording stop)
Clip 2
Counter value = A + 1
2nd card
69