Warning Information Display - Panasonic AJ-HPD2500 Operating Instructions Manual

WARNING Information Display

• A warning message is displayed whenever a warning occurs.
When no warnings have been detected, "NO WARNING" is displayed.
• When multiple warnings occur, turn the search dial to check the descriptions of each warning.
If "T&S&M" is selected in setup menu No. 006 (DISPLAY SEL), a message appears in the mode display whenever a warning
or error occurs.
Monitor display
Displayed while clip information is being read or when clip configuration has
changed. No operations can be performed while this display is on the screen.
[Meaning]
BUSY • A card has been inserted or removed
• Updating is in progress
• Recording post processing is in progress
• Other causes
Displayed when audio voice-over cannot be recorded on a P2 card.
[Meaning]
CANNOT A.DUB
• An attempt was made to record on a card that could not be used.
• An attempt was made to record when no card was inserted.
Appears in LOOP REC mode when P2 card recording is not available.
[Meaning]
• An attempt was made to record to a write protected disk.
CANNOT LOOP
• An attempt was made to record on a card with no free space available.
REC
• An attempt was made to record on a card that could not be used.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
Displayed when playback was interrupted due to a clip error or other factor.
[Meaning]
• An attempt was made to play a clip when no clips were present.
CANNOT PLAY
• An attempt was made to play back a card that cannot be used.
• The card could not be played back or playback stopped for some other reason.
• Playback was attempted when the unit was BUSY.
Displayed when data cannot be recorded on a P2 card.
[Meaning]
• An attempt was made to record to a write protected disk.
• An attempt was made to record data on a card with no more free memory space
CANNOT REC on it.
• An attempt was made to record on a card with no free space available.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
• VFR recording started but no active frame data was input.
Displayed when a memory card is protected, there is not enough space or
CANNOT REC SD recording in PH/HA mode is not available.
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
Displayed when a non-compatible SD memory card, non-standard management
CHECK SD information or mismatched thumbnail data was recognized.
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
Displayed for the first two seconds when the REC button is pressed to enter the
INT SG EE mode and the VIDEO IN (SHIFT + EDIT MODE) button or the AUDIO IN (SHIFT
+ VIDEO) button is set to SG.
INVALID IN/OUT Displayed when an attempt was made to set an IN or OUT point in a location
POINT where such points cannot be set.
Displayed when no audio track is selected or 3 or more channels are selected in
INVALID TRACK
a voice-over recording on a P2 card.
SELECT
Only 2 channels can be recorded in a voice-over recording.
Description
For Long and Trouble-Free Operation: Error Messages
Deck operation Counter display
Operation continues BUSY
Operation continues CANTADUB
STOP CANTLREC
STOP CANTPLAY
STOP CANT REC
Operation continues CANT REC
Operation continues CHK SD
Operation continues INT SG
Operation continues Counter value
Operation continues CANTADUB
205