Operation - Panasonic AJ-HPD2500 Operating Instructions Manual

OPERATION

This menu allows you to set method for engaging search dial operations, maximum shuttle speed operation, maximum speed
of FF and REW operation, NEXT and PREV seek operations, display of warning messages when REF.VIDEO is not connected,
PLAY delay time, display of warnings when power is too low, voltage when the power supply is turned off.
Item
FR SUPER
No. DISP.
0000
100 SEARCH ENA
0001
0000
0001
0002
101 SHTL MAX
0003
0004
0000
0001
0002
0003
102 FF.REW MAX
0000
0001
103 SEEK SEL
0000
104 REF ALARM 0001
0000
108 PLAY DELAY
0015
0000
0001
0002
147 WFM DISP
Setting
FR SUPER
No. DISP.
DIAL Specifies method for transferring to the search mode (search dial operation).
0: Press the SEARCH button or turn the search dial to engage search dial operation.
KEY
1: Press the SEARCH button to engage search dial operation.
×8 Sets the maximum shuttle speed operation.
16 0: 8× normal speed
×
1: 16× normal speed
×32
2: 32× normal speed
×60
3: 60× normal speed
×100
4: 100× normal speed
32 Sets the maximum speed of FF and REW operation.
×
0: 32× normal speed
×60
1: 60× normal speed
×100
2: 100× normal speed
SEEK
3: Seek operation to start of clip
NOTE:
• When SEEK is selected, FF and REW operations for FF and REW commands
transferred via 9P and RS-232C are performed at 100× normal speed. Note that seek
operations initiated by the FF and REW commands via 9P behave differently when
ORIG is set in setup menu No. 202 (ID SEL). The cursor moves to left or right in
thumbnail screens.
• The seek operation is available in playback mode.
CLIP Specifies where a NEXT (SHIFT+FF) and PREV (SHIFT+REW) seek operation moves to.
0: The start of the clip
CLIP&T
1: The start of the clip or video text memo
NOTE:
This setting is not available during FF and REW operation.
OFF Selects whether or not a warning should appear when REF.VIDEO is not connected.
ON 0: Displays no warning
1: Flashes the STOP lamp to warn
0 Sets PLAY delay time in frame increments.
| |
15
OFF
Selects wave form monitor (WFM) display mode.
0: Not displayed
WAVE
1: Waveform display
VECTOR
2: Vector display
NOTE:
• Wave form is displayed on the output destination selected in setup menu No.005
(SUPER).
• Wave form is not output to the composite connector.
• When wave form is output to the destination other than the LCD monitor,
superimposed information cannot be displayed.
• Wave form of the original signal is displayed on the LCD monitor. Wave form of the
signal adjusted by the encoder VR (setup menus No.662, No.663, No.664 (V LEVEL,
C LEVEL, HUE/C PHASE)) is displayed on other destinations.
• XX indicates factory default settings.
Settings and brief function description
177
Setup: Item Settings