Panasonic AJ-HPD2500 Operating Instructions Manual page 132

HTTP CLIENT:
Item Description
START PAGE URL URL of page displayed when
browser starts up
PROXY SERVER Turns PROXY server on or off
PROXY SERVER URL Name or address of a PROXY
server
PROXY SERVER Number of port used for
PORT PROXY
Setting server service
Use the steps below to set up any of the following services. A
service that is set to ENABLE can be started up and used.
FTP server Receives access from an FTP client and
service: transfers files. However, it cannot write
files to P2 cards.
Samba server Allows you to load P2 cards and hard
service: disks externally as network drives. (But it
cannot write data to P2 cards.)
HTTP server Allows you to view P2 card thumbnails,
service: metadata and play back proxy data (only
when the client supports playback) using
an external browser.
◆ NOTE:
• You must switch to LAN mode to use these network services.
Recording and playback and other operations are not available in
LAN mode.
➝ Refer to "Using Server Functions" (page 140).
• A server service cannot be used to write data to a P2 card. Only an
FTP client can be used to write data to P2 cards.
Item Description
HOSTNAME Host name
(up to 31 characters)
FTP FTP server setting
SAMBA SAMBA setting
WORKGROUP Work group
(up to 31 characters)
HTTP HTTP server setting
USER LOGIN User settings
SETTING
• The set password cannot be displayed on this unit. If you forget the password, etc., choose [NETWORK] – [INITIALIZE] in the
menu and press the SET button to initialize the settings. This clears user ID and password.
132
Connections: Connecting This Unit to a Network
Setup procedure
Enter using the full keyboard.
ENABLE: Enables PROXY server
DISABLE: Disables PROXY server
Enter using the full keyboard
Enter using the ten keypad
1
Open the thumbnail screen.
2
Press the MENU button.
3
Use the cursor buttons to choose [NETWORK] –
[SETUP] – [SERVER] and press the SET button.
4
The server screen appears.
Current settings appear. Use the cursor buttons to select
an item and press the SET button to set it.
Setting
Enter using the full keyboard.
ENABLE: Starts up FTP server.
DISABLE: Does not start up FTP server.
ENABLE: Starts up SAMBA service.
DISABLE: Does not start up SAMBA service.
Enter using the full keyboard.
ENABLE: Starts up HTTP server.
DISABLE: Does not start up HTTP server.
Sets user ID and password for login user. (Opens a
separate screen.)
Factory defaults
http://pro-av.panasonic.net/
DISABLE
No setting
8080
Initial value
AJ-HPD2500
ENABLE
ENABLE
WORKGROUP
ENABLE
Only guest is registered.
(PASSWORD : p2guest)