Panasonic AJ-HPD2500 Operating Instructions Manual page 197

Memory card recorder
Hide thumbs Also See for AJ-HPD2500:
Table of Contents

Advertisement

*4
Menu
TCG
No. 507 EXT
No. 518 VITC
*5
switch
TC SEL
INT
(REGEN /
---
PRESET)
EXT_L
EXT
SLTC
SVITC
*1: The internal TCG value is used when a signal cannot be detected from the TIME CODE IN connector input.
*2: The internal TCG value is used when the SLTC, SVITC and VITC cannot be detected on the input video signal.
*3: Nothing is recorded if the SVITC and VITC cannot be detected on the input video signal.
*4: When setup menu No. 25 (SYSTEM FREQ) is set to 59-23, 60-24 or 60-25, setup menu No. 507 (EXT TC SEL) does not appear. The unit is
locked in SLTC in this mode.
*5: When setup menu No. 040 (VFR REC) is set to ON, REC RUN is selected regardless of the TCG switch setting.
*6: During up-conversion recording, the selected video input signal is displayed as CMPST (U/C) and SDSDI (U/C).
➝ Refer to "VIDEO IN (SHIFT + EDIT MODE) buttons" (page 24).
CTL Mode
1
Menu
Selected video
input signal
GEN
HD SDI
OFF
Internal TCG value
*6
CMPST / SD SDI
HD SDI
ON
Internal TCG value
*6
CMPST / SD SDI
HD SDI
Time code on TIME CODE IN
OFF
*6
connector input
CMPST / SD SDI
HD SDI
ON
Time code on TIME CODE IN connector input
*6
CMPST / SD SDI
HD SDI
SLTC on input video signal
OFF
*6
VITC on input video signal
CMPST / SD SDI
HD SDI
SLTC on input video signal
ON
*6
VITC on input video signal
CMPST / SD SDI
HD SDI
SVITC on input video signal
OFF
*6
VITC on input video signal
CMPST / SD SDI
HD SDI
SVITC on input video signal
ON
*6
VITC on input video signal
CMPST / SD SDI
Recorded time code
SBC area
*1
*2
*2
*2
*2
*2
*2
*2
*2
1
Use the COUNTER button to select [CTL].
During playback, the counter displays the play position
relative to the start position.
Recording starts from the counter value [0:00:00:00].
When recording stops, the counter shows the position
relative to the start position.
◆ NOTE:
• When 23.98, 24, 59-23 or 60-24 is selected in setup menu
No. 25 (SYSTEM FREQ), there is a 1-frame delay between
playback video and CTL.
Setup: Time Code, User Bit and CTL
VAUX area
*3
SVITC on input video signal
*3
VITC on input video signal
*3
SVITC on input video signal
*3
VITC on input video signal
*1
*3
SVITC on input video signal
*3
VITC on input video signal
*3
SVITC on input video signal
*3
VITC on input video signal
197

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-hpd2500pAj-hpd2500e

Table of Contents