Panasonic AJ-HPD2500 Operating Instructions Manual page 33

5.
U lamp
In the EE mode, this lamp lights when an input signal
contains UMID information.
Lights during playback when the recording contains
UMID information.
Goes off in the playlist mode.
6.
WIDE lamp
This lamp lights when 16:9 aspect ratio (wide) data is
recorded on a P2 card in SD mode.
Use the setup menu No.645 (WIDE SELECT) to specify
whether or not wide data be recorded.
This lamp lights to indicate that 16:9 aspect ratio data
is recorded when playing back a clip recorded in SD
mode.
This lamp goes off in the playlist mode.
7.
REC/REC INH lamp
Indicates selected recording status of a P2 card.
REC lamp on: Lights in recording mode.
REC INH lamp Lights when recording is disabled
on: (when the REC INH switch on the
front panel is lit or all P2 cards are
write protected).
No recordings can be made on P2
cards when this lamp is on.
8.
Format display
Indicates the recording format or the format of video
recorded on inserted P2 cards.
9.
Counter display
Indicates the CTL, TC and UB counter and time code
values.
CTL: Relative position from the beginning.
TC: Read time code.
UB: User bits of read time code.
10.
Operating mode
Indicates the operating status of this unit.
: Normal playback and recording
: Playback at speeds lower than 1×
: Playback at speeds higher than 1×
: FF
: Reverse playback at 1× speed
: Reverse playback at speeds lower than
1×
: Reverse playback at speeds higher than
1×
: REW
: STILL
Introduction: Control Reference Guide
33