D-Link DGS-3620-52P Manual page 810

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
candidate RP and the multicast group address, to calculate the hash algorithm used by the
router to determine which CRP on the PIM-SM enabled network will be the RP.
<value 0-32> - Enter the hash mask lenght value here. This value must be between 0 and 32.
The default value is 30 seconds.
bootstrap_period - Specifies the interval between originating Bootstrap message.
<value 1-255> - Enter the bootstrap period value used here. This value must be between 1
and 255. The default value is 60 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the C-BSR for the System interface :
DGS-3620-28SC:admin# config pim cbsr ipif System priority 255
Command: config pim cbsr ipif System priority 255
Success.
DGS-3620-28SC:admin#
73-7 show pim cbsr
Description
This command is used to list the candidate bootstrap router related information.
Format
show pim cbsr {ipif <ipif_name 12>}
Parameters
ipif - Specifies the IP interface used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
If no parameter is specified, the system will display all C-BSR configurations.
Restrictions
None.
Example
To display the C-BSR settings:
DGS-3620-28SC:admin# show pim cbsr
Command: show pim cbsr
PIM Candidate-BSR Table
805