D-Link DGS-3620-52P Manual page 1039

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
103-1 download
Description
This command is used to download a new firmware or a switch configuration file.
Format
download [firmware_fromTFTP [<ipaddr> | <ipv6addr> | <domain_name 255>] src_file
<path_filename 64> {[unit <unit_id> | all]} {dest_file <pathname>} {boot_up} | cfg_fromTFTP
[<ipaddr> | <ipv6addr> | <domain_name 255>] src_file <path_filename 64> {[unit <unit_id> |
all]} {[increment | dest_file <pathname>]}]
Parameters
firmware_fromTFTP - Download and install new firmware on the switch from a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Specifies the domain name of the TFTP server. This name can be up
to 255 characters long.
src_file - Specify the path name and file name of the TFTP server. It can be a relative path name
or an absolute path name. If path name is not specified, it refers to the TFTP server path. The
maximum length is 64 characters.
<path_filename 64> - Specify the path name and file name of the TFTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to the
TFTP server path. The maximum length is 64 characters.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
all - Specifies that all the units in the stacking system will be used.
dest_file - (Optional) Specify an absolute path name on the device file system. If path name is
not specified, it overwrites the bootup image on the Switch.
<pathname> - Specify an absolute path name on the device file system.
boot_up - (Optional) Specify as boot up file.
cfg_fromTFTP - Download and install new configuration file on the switch from a TFTP server.
<ipaddr> - Specify the IP address of the TFTP server.
<ipv6addr> - Specify the IPv6 address of the TFTP server.
<domain_name 255> - Specifies the domain name of the TFTP server. This name can be up
to 255 characters long.
src_file - Specify the path name and file name of the FTP server. It can be a relative path name
or an absolute path name. If path name is not specified, it refers to the TFTP server path. The
maximum length is 64 characters.
<path_filename 64> - Specify the path name and file name of the FTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to the
TFTP server path. The maximum length is 64 characters.
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
all - Specifies that all the units in the stacking system will be used.
increment - If increment is specified, then the existing configuration will not be cleared before
applying of the new configuration. If it is not specified, then the existing configuration will be
cleared before applying of the new configuration.
dest_file - (Optional) Specify an absolute path name on the device. If path name is not specified,
it refers to the boot up configuration file.
<pathname> - Specify an absolute path name on the device.
Restrictions
Only Administrator-level users can issue this command.
1034