D-Link DGS-3620-52P Manual page 841

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To configure the multicast routing keepalive period to be 220 seconds:
DGS-3620-28SC:admin# config pim6 keepalive_period 220
Command: config pim6 keepalive_period 220
Success.
DGS-3620-28SC:admin#
74-23 show pim6 mroute s_g
Description
This command is used to display the multicast routing information for (S, G) or (S, G, rpt) entries
generated by PIM6.
Format
show pim6 mroute s_g {rpt} {group <ipv6addr> source <ipv6addr> {ipif <ipif_name 12>}}
Parameters
rpt - (Optional) Specifies the (S, G, rpt) entry.
group - (Optional) Specifies the IPv6 multicast group address.
<ipv6addr> - Enter the IPv6 multicast group address used here.
source - (Optional) Specifies the source IPv6 interface.
<ipv6addr> - Enter the IPv6 interface network address used here.
ipif - Specifies the IPv6 interface name.
<ipif_name 12> - Enter the IPv6 interface name here. This name can be up to 12
characters long.
If no parameter is specified, the switch will display all the (S, G) route entries in the IPv6 multicast
routing table in brief.
If only specified parameter {rpt}, the switch will display all the (S, G, rpt) route entries in the IPv6
multicast routing table in brief.
Restrictions
None. (EI Mode Only Command)
Example
To show all (S, G) route entries generated on the switch:
DGS-3620-28SC:admin# show pim6 mroute s_g
Command: show pim6 mroute s_g
(S, G) Entry Table
------------------------
Group : FF13::100
Source : 2001::1111
Group : FF13::100
Source : 2001::2222
836