D-Link DGS-3620-52P Manual page 782

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To set OSPFv3 router ID:
DGS-3620-28SC:admin# config ospfv3 router_id 1.1.1.1
Command: config ospfv3 router_id 1.1.1.1
Success.
DGS-3620-28SC:admin#
70-5 create ospfv3 area
Description
This command is used to create an OSPFv3 area.
Format
create ospfv3 area <area_id> type [normal | stub {stub_summary [enable | disable] | metric
<value 0-65535>}]
Parameters
<area_id> - Specifies the OSPFv3 area's ID. It is a 32-bit number in the form of an IPv4 address
that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
type - Specifies the OSPFv3 area mode of operation. There are two types:
normal - Specifies that the OSPFv3 area will be created as a normal area.
stub - Specifies that the OSPFv3 area will be created as a stub area.
stub_summary - (Optional) Specifies the OSPFv3 stub area to import inter-area prefix
LSA advertisements or not.
enable - Import inter-area prefix LSA into this stub area.
disable - Do not import inter-area prefix LSA into this stub area.
metric - (Optional) Specifies the default cost of OSPFv3 stub area.
<value 0-65535> - Enter the metric value used here. This value must be between 0 and
65535. The default value is 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To create OSPFv3 areas:
777