D-Link DGS-3620-52P Manual page 825

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
To show the detailed info of the PIM6 protocol concerned parameters on the interface "System":
DGS-3620-28SC:admin# show pim6 ipif System
Command: show pim6 ipif System
Interface Name
Interface Link-Local Address
PIM6 Mode
State
Designated Router
Designated Router Priority
Designated Router Priority Enabled
Hello Interval
Triggered Hello Interval
Hello Holdtime
Join Prune Interval
Join Prune Holdtime
LAN Delay Enabled
Propagation Delay
Override Interval
Effective Propagation Delay
Effective Override Interval
Join Suppression Enabled
Bidirectional Capable
BSR Domain Border
Stub Interface
DGS-3620-28SC:admin#
74-3 config pim6 cbsr
Description
This command is used to set the parameters concerned with the candidate bootstrap router.
Format
config pim6 cbsr {ipif <ipif_name 12> state [enable | disable] | priority <value 0-255> |
hash_masklen <value 0-128>} (1)
Parameters
ipif - (Optional) Specifies the IP interface used in this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
state - (Optional) Specifies whether the input interface can be a C-BSR or not.
enable - Specifies that the input interface will be a C-BSR.
disable - Specifies that the input interface will not be a C-BSR.
priority - (Optional) Specifies the C-BSR priority value.
<value 0-255> - Enter the C-BSR priority value here. This value must be between 0 and 255.
The default value is 64.
hash_masklen - (Optional) Specifies the length (in bits) of the mask. It makes use of a hash
function for the case where a group range has multiple RPs with the same priority.
<value 0-128> - Enter the length of the mask value here. This value must be between 0 and
: System
: FE80::207:E9FF:81D
: SM
: Enabled
: FE80::207:E9FF:FACC
: 1
: True
: 30 sec
: 5 sec
: 105 sec
: 60 sec
: 210 sec
: True
: 1 sec
: 3 sec
: 1 sec
: 3 sec
: True
: False
: Disabled
: Disabled
820