D-Link DGS-3620-52P Manual page 840

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
config pim6 register_suppression_time <sec 0-65535>
Parameters
register_suppression_time - Specifies the period during which a PIM DR stops sending
Register-encapsulated data to the RP after receiving a Register-Stop message.
<sec 0-65535> - Enter the register suppression time value here. This value must be between
0 and 65535 seconds. The default value is 60 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To configure the PIM6-SM register suppression time to be 120 seconds:
DGS-3620-28SC:admin# config pim6 register_suppression_time 120
Command: config pim6 register_suppression_time 120
Success.
DGS-3620-28SC:admin#
74-22 config pim6 keepalive_period
Description
This command is used to configure the PIM6-SM multicast routing entry Keepalive Timer. This is
the period during which the PIM router will maintain (S, G) state in the absence of explicit (S, G)
local membership or (S, G) join messages received to maintain it.
Format
config pim6 keepalive_period <sec 120-65535>
Parameters
keepalive_period - Specifies the period during which the PIM router will maintain (S, G) state in
the absence of explicit (S, G) local membership or (S, G) join messages received to maintain
it.
<sec 120-65535> - Enter the keep-alive period value here. This value must be between 120
and 65535 seconds. The default value is 210 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
835