D-Link DGS-3620-52P Manual page 1058

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
telnet [<ipaddr> | <domain_name 255> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - Specify the IP address of the Telnet server.
<domain_name 255> - Specify the domain name of the telnet server.
<ipv6addr> - Specify the IPv6 address of the Telnet server.
tcp_port - (Optional) Specify the Telnet server port number to be connected to. If not specified,
the default port is 23.
<value 1-65535> - Enter a value between 1 and 65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To Telnet to a switch by specifying the IP address:
DGS-3620-28SC:admin#telnet 10.1.1.1
Command: telnet 10.1.1.1
Copyright(C) 2012 D-Link Corporation. All rights reserved.
UserName:
103-21 enable broadcast_ping_reply
Description
The enable broadcast_ping_reply command used to enable broadcast ping reply state, device will
reply broadcast ping request.
Format
enable broadcast_ping_reply
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
DGS-3620-28SC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 2.00.015
1053