D-Link DGS-3620-52P Manual page 565

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
47-11 config jwac quarantine_server_error_timeout
Description
This command is used to set the quarantine server error timeout. When the quarantine server
monitor is enabled, the JWAC switch will periodically check if the quarantine works okay. If the
switch does not receive any response from quarantine server during the configured error timeout,
the switch then regards it as not working properly.
Format
config jwac quarantine_server_error_timeout <sec 5-300>
Parameters
<sec 5-300> - Specify the error timeout interval.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the quarantine server error timeout:
DGS-3620-28SC:admin#config jwac quarantine_server_error_timeout 60
Command: config jwac quarantine_server_error_timeout 60
Success.
DGS-3620-28SC:admin#
47-12 config jwac
Description
This command is used to configure the quarantine server URL. If the redirection is enabled and the
redirection destination is a quarantine server, when a HTTP request from an unauthenticated host
which is not headed to a quarantine server reaches the Switch, the Switch will handle this HTTP
packet and send back a message to the host to make it access the quarantine server with the
configured URL. When the PC connected to the specified URL, the quarantine server will request
the PC user to input the user name and password to authenticate.
Note: If the quarantine server is linked to the JWAC enabled port on the switch, it must
be added to the static FDB correctly before it can work properly.
Format
config jwac [quarantine_server_url <string 128> | clear_quarantine_server_url]
560