D-Link DGS-3620-52P Manual page 1071

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a user-defined OUI of a voice device:
DGS-3620-28SC:admin#config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-
00
Command: config voice_vlan oui add 00-0A-0B-00-00-00 FF-FF-FF-00-00-00
Success.
DGS-3620-28SC:admin#
105-5 config voice_vlan ports
Description
This command is used to enable or disable the voice VLAN function on ports or mode per port.
Format
config voice_vlan ports [<portlist>|all] [state [enable |disable]|mode [auto { [tag
|untag]}|manual] ]
Parameters
<portlist> - Specify a range of ports to set.
all - Specify to set all ports.
state - Specify the voice VLAN function state on ports. The default state is disabled.
enable - Specify to enable the voice VLAN function state on ports.
disable - Specify to disable the voice VLAN function state on ports.
mode - The voice VLAN mode. The default mode is auto.
auto - When the mode is auto, the port may become the voice VLAN member port by auto-
learning. If the MAC address of the received packet matches the configured OUI, the port
will be learned as dynamic member port. The dynamic membership will be removed via the
aging out mechanism.
manual - When the mode is set to manual, the port needs to be manually added into or
removed from the voice VLAN by 802.1Q VLAN configuration command.
tag | untag – Specify the port to join the voice VLAN as a tagged or an untagged member.
1. When the port is working in auto tagged mode, and learns about a voice device through
the device's OUI, it will join the voice VLAN as a tagged member automatically. When the
voice device sends voice VLAN tagged packets, the switch will change its priority. When
the voice device sends untagged packets, it will forward them to the port's PVID VLAN.
2. When the port is working in auto untagged mode, and the port captures a voice device
through the device's OUI, it will join the voice VLAN as an untagged member
automatically. When the voice device sends voice VLAN tagged packets, the switch will
change its priority. Should the voice device send untagged packets, the switch will assign
priority to those and add the voice VLAN ID in this packet.
3. When the switch receives LLDP-MED packets, it checks the VLAN ID, tagged flag and
priority flag. The switch should follow the tagged flag and priority setting.
By default, the mode is auto untagged.
1066