AT Command Set
4.11.1 Wake up the ME from SLEEP mode
A wake-up event is any event that switches off the SLEEP mode and causes the ME to return to full
functionality. In short, it takes the ME back to AT+CFUN=1.
Definitions of the state transitions described in Table 7:
Yes = ME exits SLEEP mode.
No = ME does not exit SLEEP mode.
Table 7: Wake-up events in NON-CYCLIC and CYCLIC SLEEP mode
Event
Ignition line
/RTS0 (falling edge)
Unsolicited Result Code (URC)
Incoming voice or data call
Any AT command
(incl. outgoing voice or data call, outgo-
ing SMS)
Incoming SMS depending on mode se-
lected by AT+CNMI:
AT+CNMI=0,0 (= default, no indication
upon receipt of SMS)
AT+CNMI=1,1 (= displays URC upon
receipt of SMS)
GPRS data transfer
RTC alarm
AT+CFUN=1
Recommendation:
· In NON-CYCLIC SLEEP mode, you can set an RTC alarm to wake up the ME and return to full
functionality. This is a useful approach because, in this mode, the AT interface is not accessible.
MC35_ATC_01_V05.00
From SLEEP mode
AT+CFUN=0 to
AT+CFUN=1
No
Yes
Yes
Yes
Not possible
(UART disabled)
No
Yes
Not possible
(UART disabled)
Yes
Not possible
(UART disabled)
Page 81 of 256
From SLEEP mode
AT+CFUN=5 or 6 to
AT+CFUN=1
No
No
Yes
Yes
No
No
Yes
No
Yes
Yes
15.07.2002