Atl Set Monitor Speaker Loudness; Atm Set Monitor Speaker Mode; Ato Switch From Command Mode To Data Mode / Ppp Online Mode - Siemens MC35 Command Set

AT Command Set

2.15 ATL Set monitor speaker loudness

Execute command Response
OK
ATL[val]
Reference Note
· The two commands ATL and ATM are implemented only for V.25ter compatibil-
V.25ter
ity reasons and have no effect.
· In multiplex mode the command is supported on logical channel 1 only.

2.16 ATM Set monitor speaker mode

Execute command Response
OK
ATM[val]
Reference Note
· The two commands ATL and ATM are implemented only for V.25ter compatibil-
V.25ter
ity reasons and have no effect.
· In multiplex mode the command is supported on logical channel 1 only.

2.17 ATO Switch from command mode to data mode / PPP online mode

Execute command Response
ATO[n] ATO is the corresponding command to the +++ escape sequence described in
Chapter 2.2: When you have established a CSD call or a GPRS connection and
TA is in command mode, ATO causes the TA to resume the data or GPRS con-
nection and takes you back to data mode or PPP online mode.
If connection is not successfully resumed
NO CARRIER
or
TA returns to data or PPP online mode from command mode
CONNECT <text>
Note:
Parameter
<n>
Reference Note
V.25ter
MC35_ATC_01_V05.00
<text> output only if +ATX parameter setting with value > 0.
0 switch from command mode to data or PPP online mode
Page 31 of 256 15.07.2002