Siemens MC35 Command Set page 10

AT Command Set
5.10 149
5.11 152
6.1.7 172
6.1.8 173
6.3.2 176
8.2 186f
8.3 188
8.15 202
8.19 - 8.28 205 - 212
8.25 210
8.37 222
8.38 224
9.1.3 231
9.1.4 234
9.1.5 237
9.3 248f
MC35_ATC_01_V05.00
SIM card (ME returns OK or ERROR depending on
setting of AT^SM20).
Statement about sending e-mails via SMS corrected:
If not recognized by provider, @ may be replaced with
"*".
AT+CNMI Notes regarding AT^SSCONF and AT^SMGO added.
Note regarding the handling of Class 0 short mes-
sages added.
AT+CPMS <mem3> now offers the choice between "MT" and
"SM"
<mem1>, <mem2> and <mem3> are now stored non-
volatile.
Added notes on handling <mem3>.
AT+CGSMS Modified parameter <service>=2 (GPRS preferred):
No SMS via GPRS during a circuit switched call.
AT^SGAUTH Notes added: Parameter cannot be stored with
AT&W. Default value after power-up is <auth>=3
(PAP and CHAP).
ATH Notes on deactivation of PDP context and GPRS con-
nection removed.
AT^MONI Response example b): Parameter C1 corrected.
<chann> and <rs> explained in greater detail
References for 3GPP TS 05.05 and 05.08 added
Notes modified:
If the radio cell changes during a connection, the pa-
rameters PWR and RXLev of the 'Serving Cell' part
will not be updated, and updating the Cell ID takes 1
or 2 seconds.
AT^MONP <chann> and <rs> explained in greater detail
Notes modified: During a connection new neighbour
cells can be added, but their parameters C1 and C2
will be updated after the call.
AT^SMGO Added
AT+CNMI=3,1. SMS indication during data transfer
via Break (100ms)
AT^SNF... All Chapters revised.
AT^SNFPT New AT command: Call progress tones
AT^SRTC New AT command: Select, query, test ringing tones
AT^SSCONF New AT command: Configuring recipient address pa-
rameters in SMS result codes and in +CDS URCs.
CMS errors Note and example added: Mapping of CME and CMS
errors if SIM PIN authentication has not been done.
URCs Added: URCs will be output after command execution.
Added list of Fax Class 2 URCs.
Result codes Removed 3 result codes "CONNECT...", and pre-
served those wich include "CONNECT .../RLP"
Added to List of PIN1 requiring AT commands:
AT+CPIN2, AT^SSDA
Added to List of PIN1 independent AT commands:
AT+VTS, AT^SNFPT, AT^SRTC, AT^SSCONF
Page 10 of 256
note: Indication of URC requires
15.07.2002