At+Fdr Begin Or Continue Phase C Data Reception; At+Fdt Data Transmission - Siemens MC35 Command Set

AT Command Set

3.11 AT+FDR Begin or continue phase C data reception

Execute command
AT+FDR
Reference
EIA PN-2388

3.12 AT+FDT Data Transmission

Execute command
AT+FDT
Write command
AT+FDT =<dt>
Reference
EIA PN-2388
MC35_ATC_01_V05.00
The +FDR command initiates transition to Phase C data reception.
Response
CONNECT
or
OK
If error is related to ME functionality:
ERROR
Note
Used for Faxclass 2 only
This command requests the ME to transmit a Phase C page. When the ME is
ready to accept Phase C data, it issues the negotiation responses and the
CONNECT result code to the application.
In Phase B, the +FDT command releases the ME to proceed with negotiation,
and releases the DCS message to the remote station. In Phase C, the +FDT
command resumes transmission after the end of a data stream transmited be-
fore.
Response
CONNECT
Response
CONNECT
Parameter
<dt> DF,VR,BR,WD,LN comma separated parameter list
Data Compression Format
Vertical Resolution
Bit Rate
Page Width
Page Length
Note
Used for Faxclass 2 only
Page 56 of 256
DF 0 1-D modified Huffman
1 2-D modified read
2 2-D uncompressed mode
VR 0 normal, 98 lpi
1 fine, 196 lpi
BR 0 2400 bit/s, V.27ter
1 4800 bit/s, V.27ter
2 7200 bit/s, V.29
3 9600 bit/s, V.29
WD 0 1728 pixels in 215mm
1 2048 pixels in 255 mm
2 2432 pixels in 303 mm
3 1216 pixels in 151 mm
4 864 pixels in 107 mm
LN 0 A4, 297mm
1 B4, 364mm
2 unlimited length
15.07.2002