At+Cr Service Reporting Control - Siemens MC35 Command Set

AT Command Set

4.39 AT+CR Service reporting control

Test command Response
+CR: (list of supported <mode> s) OK
AT+CR=?
Parameter
See write command
Read command Response
+CR: <mode> OK
AT+CR?
Parameter
See write command
Write command Response
Configures the TA whether or not to transmit an intermediate result code +CR:
AT+CR=<mode>
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during con-
nect negotiation when the TA has determined the speed and quality of service
to be used, before any error control or data compression reports are transmit-
ted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv >
Parameter
<serv>
Reference Note
GSM 07.07 The PLMN influences the second air interface (to the terminator), therefore an-
other mode may be established from the network
MC35_ATC_01_V05.00
1 enable
REL ASYNC asynchronous non-transparent
Page 122 of 256 15.07.2002