AT Command Set
2.18 ATQ Set result code presentation mode
Write command
Response
ATQ[<n>]
Specifies whether or not the TA transmits any result code to the TE. Information
text transmitted in response is not affected by this setting.
If <n>=0:
OK
If <n>=1:
(none)
Parameter
<n>
Reference
Note
V.25ter
2.19 ATP Select pulse dialling
Execute command
Response
OK
ATP
Reference
Note
V.25ter
No effect for GSM
2.20 ATS0 Set number of rings before automatically answering the call
Read command
Response
ATS0?
<n> OK
Write command
Specifies whether or not the TA will accept an incoming data / fax call without
ATS0=<n>
user intervention. <n> determines the number of rings to wait before the TA will
automatically answer.
Response
OK
Parameter
<n>
Reference
Note
· Auto-answer mode is only applicable to data or fax calls.
V.25ter
· If <n> is set too high, the calling party may hang up before the call can be
· The correlation between ATS7 and ATS0 is important.
MC35_ATC_01_V05.00
0 DCE transmits result code
1 Result codes are suppressed and not transmitted
000
disables automatic answer mode
001-255 enables automatic answering after specified number of rings
automatically answered.
Example: Call setup may fail if ATS0=20 and ATS7=30.
Page 32 of 256
15.07.2002